Material Data Safety Sheets for Bullseye glass

[tjw]

I'm experimenting the laser etching glass in my Glowforge, and realizing that before I do too much of this, I should ask about MDS data for Bullseye glass. I know a while ago there were issues with Bullseye needing better formulas/environmental filtering on its output, so I'm reminded that I should check on this before vaporizing too much glass.

Specifically, I'm currently testing etching patterns that remove the iridescent coating on one of the black sheet glasses.

Thanks!

[tjw]

Oops, attachment of the etch in progress didn't come through, so here is the piece after the full run and just before hoping into the kiln with a clear cap

https://twitter.com/tjw/status/1360865780519247873