bullseyeglass.com • View topic - drop ring molds

drop ring molds

For discussion of processes related to using Bullseye glass, including kilnforming and kilncasting, torchwork, blowing and stained glass.

drop ring molds

Postby krudberg » Wed Feb 03, 2010 5:45 pm

I'm going to be trying fusing with drops ring molds this weekend, and I was wondering if anyone has any tips for successful pieces?

-kr.
krudberg
 

Re: drop ring molds

Postby Roberta Ayles » Thu Feb 04, 2010 8:16 am

Don't raise the ring off the shelf very far to begin with (say 4cm). The sides can get quite thin if you go higher. Go very slowly as you approach slumping temps, and keep looking in.
Roberta Ayles
 
Posts: 7
Joined: Thu Jan 28, 2010 7:28 am


Return to Technique

Who is online

Users browsing this forum: No registered users and 1 guest