My current controller ST501 is older type without pause resume facility.
need to be able to go to cooling schedule immediately glass is seen to have slumped sufficiently.
Below is my idea to circumvent current problem temporarily(until I sort either circuit board,or whole new controller)
Can anyone advise re this and circuit board versus whole new controller ?
Controller company and kiln company said so far that
within a schedule/prog not possible to skip on etc
Was thinking of ways to use current controller until this is decided on.
Thinking to schedule slow slump program
and a schedule that just deals with the cooling ramps.(unsure if possible)
(It's possible to halt a program during firing)
Could use slow slump prog;watch
If necessary halt and start with cooling ramps.